 Jacking
System can be fitted by a handy man, caravan repair
specialist or adequate workshop. Fitting instructions
are supplied with unit.
NOTE: No Hydraulic lines are supplied with jacking system
 Operating
Fluid
The operating fluid is LIGHT HYDRAULIC OIL (can be topped
up with BIKE FORK OIL 5)
Top up tank with jacks folded up to within 2.5cm (1")
of the Filler Plug
Operating
Instructions
1.
Check lay of van and release car brakes, if van is still
attached to car.
2. Close Release Valve
3. Select jacks on low side by opening corresponding
valves half a turn
4. Pump handle until jack raise van just past level
and close valves.
5. Open remaining jack valves and raise van to level
- close valves
6. Check valves are all closed. Nip down on finger tight.
Avoid damage caused by using force.
TO RELEASE
1.
Release all jack valves half a turn.
2. Gently open release valve and springs will return
jacks to folded position.
3. Check jacks are fully folded and close all valves
NOTE:
If jacks have bedded into ground and do not fold, simply
drive van forward slowly.
To avoid bedding in or for soft ground conditions, pieces
of hardwood 8" x 3" x 1" placed under
jacks allow them to do the job they were designed for.
| Feature |
Benefit |
| The
pump box is coated with Baked Zinc Aluminium on
the inside and outside as well as on the four legs. |
The
non-corrosive surface on the outside prevents the
paint from peeling. There is no corrosion inside
caused by air gap condensation and therefore no
damage to the O-Rings by rust particles |
| Two
piece pump handle |
Allows
handle to be removed and stored, it fits easily
in the pump box |
| Pump
has a latch down weather proof lid |
Prevents
pump mechanism and valves from being tampered with
or vandalised. Reduces dust, corrosion and damage
to valves and pump mechanism |
| All
hydraulic cylinders are finely machined |
Increases
O=Ring life and so reduces maintenance |
| Hydraulic
rams are made from high tensile steel |
Prevents
surface rust in corrosive environments when the
legs are in the down position |
| High
quality dust seal in ram cap |
When
stabilisers are being raised the seal wipes off
surface dust thus protecting |
| All
O-Rings are standard sizes |
Can
be purchased from most hydraulic outlets Australia
wide |
|
